Sativa makes a good point, you might need a custom cabinet maker to get the integrated look with flush mount and minimal gap. That's the 42' Sativa, I think they want something a minimum of 48' for cubic ft. I think the OP is going without a dispenser, inside or out. Uh, you seem to be interested in paneled. Have you messed around with a SS SZ in a showroom? Tried to smudge them with your hands? Just a thought. I can't help with the fingerprint issue, but I am guessing you already know they say they are not fingerprint free due to the finish. Too much walking about when separated, but me! I've seen it, and it's quite attractive, but for our uses, would be too far away - as you say, getting ice for water, but also when I pull things out of the fridge, I often make a grab for a freezer item. I agree, I wouldn't care for the freezer and fridge columns to be separated. Couldn't find a solution in any other brand either, though we liked the SZ's best. The integrated's are more expensive with less cubic feet, so the 48' built in, but flush install with a deeper cabinet (which we were planning anyway) was our only good option. We didn't have room for the 2, 36' columns, and the next size down in the freezer column didn't cut it either. We needed a larger fridge, and I don't like bottom freezers at all (I know, some do). We ran into the exact same problem, but without the stacked oven situation.

Sub zero integrated panel installation